Premier 412 & 816 Master User Manual System Program Menus
INS141-5 19
From
Previous Page
Led Key
Off
On
Slow Flash
Fast Flash
N
Text Editing Keys
1
2
3
4
5
6
7
8
.,?!1@” -&
abc2ABC
def3DEF
ghI4GHI
jkl5JKL
mno7MNO
pqrs7PQRS
tuv8TUV
9
0
U
R
wxyz9WXYZ
Space 0 , # *
Move Left/Right
Backspace (delete)
Use keys to enter/edit text.
Then press to accept.y
Premier 816
Banner Text
97
Premier 816
^anner Text
Press n to edit text.
Banner Text (LCD Only)
98
Print 100 Events
Walk Test
The Walk Test feature can only be performed when the
partition is disarmed. 24 hour zones (except Fire, Tamper
and Trouble) are disabled during Zone Test allowing Audible
PA buttons, Silent PA buttons, etc. to be tested.
Test Speakers & Outputs
This menu options allows you to perform the following tests:
Test Speakers
Test Bells
Test Strobes
Test System Outputs
When performing the “Test System Outputs” option,
only outputs programmed by your installer will be
activated during this test.
Send Test Call
This menu options allows you to send a test call
transmission to your Alarm Receiving Centre.
If the test call is unsuccessful, the keypad will sound
an error tone.
Enable Download/Engineer Access
Your alarm system may be configured in such a way that
you have to authorise Download/Engineer Access. Once
authorised, your alarm system will allow:
• Your installer/Alarm Receiving Centre to access the
alarm system via the remote downloading computer.
• Your installer/engineer to access the control panel
programming menus.
The alarm system will allow access until 12.00am, after
which, both Download and Engineer Access will be denied.
Start Call Back
This option will cause the control panel to initiate a call back
sequence. This will allow the remote downloading computer
to remotely access the control panel.
You should only use this feature when requested by
your installer/Alarm Receiving Centre. If the Call Back
is unsuccessful the keypad will sound an error tone.
Program Time
The control panel has a real time clock that is used to date
and time stamp events that are recorded within the system
log. The option allows you to set the control panel time.
Program Date
The control panel has a real time clock that is used to date
and time stamp events that are recorded within the system
log. The option allows you to set the date on the control
panel.
Program Banner Text (LCD only)
If the system is fitted with either a Premier LCD or LCDL
remote keypad you can assign up to 16 characters of text to
the Banner Message. The Banner Message is displayed on
the top line of the LCD display during the normal disarmed
state. Text is programmed in a similar way to mobile
phones. Characters are selected by pressing the
corresponding key the appropriate number of times (to
select a character on the same key, press
to move the
cursor along). For details on entering text, see page 14.
Print 100 Events
If your system has a printer connected, this menu option
allows the last 100 events in the system Event Log to be
sent to the printer.
To Next Page
Loading...
