Texecom PREMIER 88 - Overview of Texecom Premier Series Alarm System; System Basics and Components

Operating the Alarm System Premier Series User Guide
4 INS221
2. Operating the Alarm System
To FULL Arm the System
The system is FULL Armed when ALL zones are ON (not omitted).
!"
Your Installer may have programmed the system so that it can be set by just pressing
'
, if this is the case then there is no need to enter the User code below.
1. Ensure that the premises are secure (all doors and windows closed etc.) and the
Ready light is on
2. Enter a valid User code
,,,,
3. Press
*
to arm
The exit tone will sound
4. Leave the premises
When the system has armed the exit tone will stop
To PART Arm the System
The system is PART Armed, when ONE OR MORE zones have been left OFF (omitted)
i.e. the landing or a bedroom.
!"
The system is only Part Armed when zones are omitted using the ‘Part Arm’ procedure
(omitting zones manually (see page 8 for details) is not classed as Part Arming).
The bottom line of the display is programmable for each Part Arm.
Your Installer may have programmed the system so that it can be Part Armed by
just pressing
!
,
(
or
"
followed by
)
, if this is the case then there is
no need to enter the User code below.
1. Ensure that the premises are secure (all windows and doors not being omitted are
closed) and the Ready light is on
2. Enter a valid User code
,,,,
3. Press
)
4. Use keys
!
-
"
to select the required Part Arm
5. Press
*
to arm normally or press
-
to arm silently
The exit tone will sound (if silent arm has not been selected)
6. Leave the protected area
When the system has armed, the exit tone (if sounding) will stop