Premier 8SP User Guide
2 INS236
Operating Your Alarm System
This document covers the everyday operation of your alarm system, for details on
more advanced operation and system programming, please refer to the Premier
8SP Master User Manual.
Away Arming the System
Enter your Access code !!!! followed by the "/# key. The Armed
light will flash and the exit sounder will sound for the duration of the exit time.
Stay Arming the System
Enter your Access code !!!! followed by the $ key. The system will
normally arm immediately, the Armed light will flash slowly indicating that the
system is Stay armed.
Disarming During Entry
Enter the premises via the designated entry point. The entry tone will sound,
proceed directly to the remote keypad and enter your Access code
!!!!.
Disarming When Not in Entry
Proceed directly to the remote keypad and enter your Access code
!!!!, the Armed light will turn off.
Bypassing Zones
Enter your Access code !!!! followed by the % key. Enter the zone
or zones to be bypassed e.g. 02, 04 etc. The Ready light will flash slowly
indicating one or more zones are bypassed. When all required zones have been
selected, press:
"/# to Away arm the system with the selected zones bypassed
$ to Stay arm the system with the selected zones bypassed
& to return to the normal disarmed state with the selected zones bypassed
Reset Alarms/Faults
Enter your Access code !!!!, then press ' or enter &(.
Last Alarm Log
Enter your Access code !!!!, and then enter &). The remote
keypad will display the zones that caused an alarm when the system was last
armed. Press & to return to the normal disarmed state.
To Next Page
Loading...
Need help?
General
