Texecom Premier Elite 48-W - View ID Data; Configure Radio

Premier Elite Series Installation Manual Engineer Utilities
INS176-15 137
View iD Data
Enginee Uils
ie i aa


i oop 
apped Zone 
E o elec:
Enginee Uils
Enginee Uils
ie Een og


i oop 
apped Zone
i oop 
apped Zone
i oop 
apped Zone 
i oop 
apped Zone

Q
y

y
0
A
A
y


O
y
N
Viewing the iD Data
“iD” is a registered trade mark of Chloride Safety System Limited.
Configure Radio
Enginee Uils
onige adio
3: I433 K
:8 Zone
E o elec:
Enginee Uils
Enginee Uils
ie Een og
3: o eice 

E

o ean
3: I433 K
:8 Zone8
3: I433 K
:8 Zone 8
: I4 K
: Zone 
3: o eice 8
ciae eice
3: I433 
:8 Zone 
y
y
N
n


?
Top Line = Serial number
of device
Bottom
and status
Line = Signal strength
and zone/user number
If Device already programmed
ID will show here
y
y
Configuring Radio devices (NOT V2 Systems)
Up to 32 wireless devices can be learnt on to the system this can be
any combination of detectors, mag contacts and remote FOBs. The
number of remote FOBs is limited to the maximum number of
devices the expander can accept.
Wireless devices can then be mapped on to the system along with
conventional detectors.
The top line on the display shows the serial number of the device and
also the status i.e. Active, Tamper etc.
The bottom line of the display shows the signal strength and also
which zone/user the device is mapped to.

Signal strength should be greater than 30.
The signal range is between 0 and 90
To delete radio devices, select the device number to be deleted then
follow the procedure for learning a new device but press the R
button on the keypad when prompted to activate device instead of
activating the tamper switch.