7
Installing your unit
Open the package and remove the protective foam. Remove the protective sleeve from the
unit.
Install the Digital Picture Frame stand as the back of the unit.
Plug in the AC adapter into power outlet. Plug the other end into the unit.
After the content is stored on the target flash media; insert the media into the correct slot.
Turn power to ON position via the ON/OFF switch.
Connecting to a PC
The Digital Picture Frame has a USB port for connection to a PC (USB Slave) and a second
USB port for connection to other devices such as a Flash Drive, USB card reader, or a
camera (USB Host). When connected to the PC you can drag-and-drop content from the PC
to the internal memory or memory card. You can also delete content from the internal memory.
NOTE: USB Slave and USB Host can not be used at the same time.
To Next Page
Loading...