Texi Art Auto 2 - Page 16

Adjusting the Treadle(Fig. 18, Fig. 19, Fig. 20)
16
1.Adjusting the angle of treadle
1) Adjust the angle of treadle only by adjusting the length of treadle connecting rod:
unscrew screw ①, and adjust the length of treadle connecting rod by moving upward/
downward the
upper connecting rod ② and lower connecting rod ③.
2) Screw down screw ① when adjustment is over.
Caution:
1.To prevent the unexpected startup of sewing machine, trim off the power supply before
the operation is conducted.
①
②
③
Fig.18
Fig.19
a
b
c
d
④
⑤
2.Adjustment of the strength of pedal
The sewing machine run at a low speed when step forth on the panel slightly.If the
strength is insufficient, hang the stepping adjustment spring ④ on the panel spiral arm
driving lever ⑤ in order to adjust strength.(a is the minimum stepping strength ,b,c,d
increase gradually)
Caution:
1.To prevent the unexpected startup of sewing machine, trim off the power supply
before the operation is conducted.