6. Adjusting the presser foot pressure
Turn adjusting knob to adjust the presser foot pressure. It should be as light as possible, yet be sufficient to obtain the
proper stitch formation
7. Adjusting the differential feed ratio
- If the stroke of the main transporter is bigger than the stroke of the differential transporter, the sewn material is
stretched.
- If the stroke of the main transporter is smaller than the stroke of the differential transporter, the sewn material will be
gathered.
Loosen the nut and move the lever up or down to obtain the correct differential feed ratio. Tighten the nut after positioning
the lever as desired.
Light
To stretch
To shrink
8
TEXI Tre 04 T, Quattro 24 T, Cinque 35 T Operation Manual
To Next Page
Loading...
Need help?
General
