Texmo Industries TARO TSM ZR Series User Manual (English)

Questions and Answers:

W
Whitney DominguezJul 25, 2025
Why Texmo Industries Water Pump does not run?
- C
  Clayton LeeJul 25, 2025
  There are several reasons why your Texmo Industries Water Pump might not be running. It could be due to: * No power supply: Check if power is available. * Burnt motor coil: The motor may need rewinding. * Low voltage: Ensure operation within the recommended voltage range. * Tripped motor starter overload: Reset the overload, but if it trips again, check the voltage. * Pump jammed: Dismantle the pump to clear any jammed parts. * Blown fuse: Replace the fuse. * Loose connections: Tighten all electrical connections. * Prolonged idleness: Run the pump for a few minutes every other day to ensure free shaft rotation.
L
Louis SnyderAug 4, 2025
Why Texmo Industries Water Pump current consumption is in excess?
- D
  David CoxAug 4, 2025
  Excessive current consumption in your Texmo Industries Water Pump can stem from several issues: * Damaged thrust bearing: Replace the worn-out bearing. * Low voltage: Check the voltage supply. * Defective rotor: Replace the rotor. * Excessive wear: Service the pump, replacing worn parts. * Low system head: Throttle the discharge.
A
Angela DaviesAug 9, 2025
Why is the total head developed by my Texmo Industries Water Pump too low?
- H
  Heather AndradeAug 9, 2025
  If your Texmo Industries Water Pump isn't developing enough head, here are a few possible reasons: * Abrasive wear: If the pump operates with water that has a high sand content or is corrosive, it can cause abrasive wear of pump hydraulics. You should change the worn-out pump parts. * Change in static head: Check the actual static head. * Low voltage: Wait for the voltage to increase.
Z
Zachary HensleyAug 14, 2025
How to fix a Texmo Industries Water Pump that runs rough and noisy?
- D
  Dustin RiveraAug 14, 2025
  A Texmo Industries Water Pump that runs roughly and noisily might have these problems: * Dry running: Keep the pump idle for some time or reduce the discharge by throttling. * Bent shaft: Replace the shaft. * Excessive wear: Service the pump, replacing the worn-out parts.
E
Edward ZamoraAug 19, 2025
What to do if Texmo Industries Water Pump leaks excessively?
- N
  nedwardsAug 19, 2025
  If your Texmo Industries Water Pump is leaking excessively, the cause may be: * Damaged gaskets/O-rings: Check and replace the gaskets or O-rings. * Damaged pipeline: Check and replace the piping.