42
NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
2. Temperature Indicator - If the engine
coolant temperature exceeds the nor-
mal operating range, the temperature
icon will begin flashing and the
LCD will go blank for 30 seconds;
then the LCD will return to normal.
However, the temperature icon will
continue to flash.
3. Mode Button - Shifts the gauge
through two operating modes:
speedometer/tachometer and MPH/
KPH.
NOTE: The Mode Button must be
pressed and released to shift speed-
ometer/tachometer modes. It must
be pressed and held to shift MPH/
KPH modes.
4. Set Button - The Set Button is used
to select the gauge display of clock,
hour meter, trip 1, trip 2, and odome-
ter. It is also used to activate the
clock set function and adjust the
minute display on the clock.
5. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.
NOTE: When the bottom segment
flashes, approximately 3.5 L (0.92
U.S. gal.) of gasoline remains in the
tank.
6. Oil Pressure Indicator - Will be dis-
played during self-test at start-up. It
will not be displayed during normal
operation as oil pressure is not moni-
tored on these models.
7. Odometer/Trip Meter - Odometer
registers the total distance the vehi-
cle has traveled. The trip meter is
resettable and can be used to mea-
sure trip or trip legs. The odometer
cannot be reset.
8. Gear Position Indicator - Indicates
which gear is currently selected - R
(reverse)/N (neutral)/L (low range)/
H (high range).
9. High Beam Indicator - The High
Beam icon will appear only when
the headlights are on high beam.
10. 4WD Lock Indicator - Displays
LOCK when the front differential
lock has been engaged. Not utilized
on this model.
11. Drive Select Indicator - Displays
4WD when selected by the drive
select switch or when the 4WD lock
is engaged. The display is blank
when in 2WD.
12. Speedometer/Tachometer - Indi-
cates the approximate vehicle speed
in miles per hour (MPH), kilometers
per hour (KPH), or RPM.
Condition Warning Display - Uses odom-
eter/trip meter display of the LCD to
warn of a system error condition requir-
ing attention.
A. Volt - The LCD will go blank
except the word VOLT will flash
on the LCD whenever a low volt-
age (<9 DC volts) or a high volt-
age (>16 DC volts) is detected.
When voltage returns to normal,
the gauge must be reset by turn-
ing the ignition key to the OFF
position and then to the ON posi-
tion.
B. EFI - The LCD will go blank
except a diagnostic trouble code
(DTC) code will flash on the
LCD and a wrench icon will be
displayed whenever an electronic
fuel injection malfunction is
detected. After 30 seconds, the
LCD will return to normal; how-
ever, the DTC and wrench icon
will continue to be displayed
until the malfunction is cor-
rected.
NOTE: Take the ATV to an autho-
rized dealer to have the EFI error cor-
rected and to have the ECM reset as
soon as possible.
To Next Page
Loading...
