59
1. Rotate the socket counterclockwise
and remove it from the housing.
2. To remove the bulb from the socket,
push in and rotate counterclockwise.
3. To install the bulb, push in and turn
clockwise.
4. Insert the socket into the housing
and rotate it clockwise.
Checking/Adjusting
Headlight Aim
The headlights can be adjusted vertically.
The geometric center of the HIGH beam
light zone is to be used for vertical aim-
ing.
1. Position the ATV on a level floor so
the headlights are approximately 6.1
m (20 ft) from an aiming surface
(wall or similar aiming surface).
ATV-0070
NOTE: There should be an average
operating load on the ATV when
adjusting the headlight aim.
2. Measure the distance from the floor
to the mid-point of each headlight.
3. Using the measurements obtained in
step 2, make horizontal marks on the
aiming surface.
4. Make vertical marks which intersect
the horizontal marks on the aiming
surface directly in front of the head-
lights.
5. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
6. Observe each headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical
mark 5 cm (2 in.) below the horizon-
tal mark on the aiming surface.
7. Adjust each headlight until correct
aim is obtained by turning the
adjuster clockwise to lower or coun-
terclockwise to raise the beam.
KC0108A
Fuses
The fuses are located in a power distribu-
tion module in front of the steering post
under the electrical access panel. If there
is any type of electrical system failure,
always check the fuses first.
NOTE: To remove the fuse, com-
press the locking tabs on either side
of the fuse cover and lift out.
2411-566
Tools
A basic tool kit is provided with the ATV.
Maintain the tool kit with the ATV at all
times.
XR191A
CAUTION
Always replace a blown fuse with a
fuse of the same type and rating. If
the new fuse blows after a short
period of use, consult an authorized
dealer immediately.
To Next Page
Loading...
