350019 5 - 1 rev 7/01
SERVICE section 5
PERIODIC MAINTENANCE
Check the hydrostatic drive oil level daily. Make sure the oil is at the correct
level for hot or cold. Markings for hot or cold levels are located on the breather
level indicator.
To fill the expansion tank, unscrew the reservoir breather cap. After filling to the
correct level, replace the cap. If additional oil is required, use only Steiner
Trans--Hydraulic Oil or SAE 30 engine oil. Do not use automatic transmission
fluid, multi-grade motor oil, or any other type of hydraulic oil.
Change hydraulic oil annually.
Grease the turf rollers with Lithium--based grease every 50 hours or monthly
(whichever occurs first). (See lubrication chart below)
DO NOT GREASE CHAINS. Lubricate chains with SAE 10W-30 motor oil
every 30 hours or weekly (whichever occurs first).
Change engine oil every 100 hours of operation or bi-monthly, whichever
occurs first. Use SAE 10W-30 or SAE 10W-40 with API service designation of
SF, SF/CC, or SF/CD.
Drawing 3 - Lubrication Chart
To Next Page
Loading...
Need help?
General
