Greenlee Textron / Subsidiary of Textron Inc.
2
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
Hydraulic Punch Driver
Table of Contents
Description ..................................................................... 2
Safety ............................................................................. 2
Purpose.......................................................................... 2
Important Safety Information ......................................3-4
Setup and Operation...................................................... 5
Illustration....................................................................... 6
Parts Lists ...................................................................7-9
Description
The Greenlee hydraulic punch driver sets combine the
746 Hydraulic Ram with the 767 Hand Pump or the
1725 Foot Pump. These hydraulic driver sets are
intended to be used with either standard or Slug-Buster
®
punches and dies to punch holes through plastic,
fiberglass, aluminum and steel. Greenlee Slug-Splitter
®
punches, dies, and draw studs are capable of punching
through all of these materials and stainless steel.
Round punches are available for punching holes from
12.7mm through 144mm (1/2" through 5-5/8") in
diameter, including 1/2" through 5" conduit and pipe
sizes. Other shapes are available — square, special
square, rectangular, “D”, double “D”, electronic connec-
tor, oiltight with notches, and key.
The maximum thickness of material that the punch can
penetrate depends on the size and shape of the punch.
See the instruction manual supplied with the punch for
individual punch capacities.
Safety
Safety is essential in the use and maintenance of
Greenlee tools and equipment. This instruction manual
and any markings on the tool provide information for
avoiding hazards and unsafe practices related to the
use of this tool. Observe all of the safety information
provided.
Purpose
This manual is intended to familiarize personnel with the
safe operation and maintenance procedures for the
following Greenlee hydraulic punch driver kits:
38456
38520
7306/7306SB
7310/7310SB
7506
7606SB
7610SB
7625/7625Pg/7625PgSB
7646/7646Pg/7646PgSB
Slug-Buster
®
, Slug-Splitter
®
, and
are registered trademarks of Greenlee Textron.
Keep this manual available to all personnel.
Replacement manuals are available upon request at no
charge.
KEEP THIS MANUAL
To Next Page
Loading...
