6
14. Sleep Mode – If the Power Key is inadvertently left switched on for a period of time, the Breeze Midi will
automatically shut down into a power saving mode. To restart, switch the key off for a few seconds then switch
on again and power will be restored.
15. Fault Indicator – the ‘Power ON’ light is also used as a fault indicator. If there is a problem this light will flash
a certain code. Check it is not the parking brake release and if it is not and the light is still flashing phone your
agent or TGA for advise.
4. SEAT ADJUSTMENT
1. The seat can be swiveled and lock into one of several
positions. This allows a variety of different positions if you need
to sit at a table etc. Swiveling it within 90° allows easy entry
and exit. The lever is located on the right hand side of the
seat. When the lever is released make sure the seat locks into
place (Fig 2.2).
2. The seat adjustment lever located at the front of seat allows
the seat to be adjusted forward or backward (fig 2.1).
3. The Backrest Adjustment lever located at the RH side of the
seat allows the backrest to be adjusted for comfort.
4. Both armrests can be adjusted for angle, by use of the allen
head screws located under the armrest. The armrests can be
hinged up for easy access and the headrest can be made higher simply by pulling gently upwards.
5. The Seat Height is adjustable and can be reset by removing the seat and top cover (see previous
instruction). You will see the seat post and a bolt going through it from right to left. Remove the bolt and
pull up the inner seat post. You will see several adjustment holes. Select the one of your choice and refit.
5. DRIVING
Before driving make sure that the Battery is fully charged, check that the tyres do not appear to be soft, see
Maintenance section for details of monthly checks and tyre pressures. Check that the Key is switched OFF before
entry. When comfortably sat, ensure that the seat lever has locked the seat secure. Ensure that the armrests are in
the down position.
To Next Page
Loading...