Thames & Kosmos Candy Claw Machine - Page 6

P7
P10
P8
P20
P4
P24 x2
P6 x4
P9
P21P21
P11
P23
1
2
3
2 3
1
2
1
2
Note: Make sure the straight
arm of the spring (P20) is
tucked in the notch in P8.
Note: There
are two
shapes of the
column
pieces (P6).
Match their
bottoms to
the slots in
the base.
Slide the
columns
into the
base.
Slide the back
and side
panels into
the channels.
Place the top frame on the columns. Each
corner should click into place. The panels
will fit into the grooves of the top frame.
Place the L-shaped
end of P20 into the
small hole as shown.
Note: Peel any
thin protective
films off the
panels.
Place the left peg of
P8 into the base.
Snap the right peg
of P8 into the base.
Place the spring (P21)
onto the peg of P11.
Turn the base over.
Click into place.
4
7
8
9
10
5
6
 
See the back cover of ths
manual for an alternate setup
of the prze door