THE-ONE SPILLO - DIY Technical Solutions

6. DIY technical solutions
PROBLEM POSSIBLE CAUSES SOLUTIONS
E-scooter doesn’t turn on. 1. Low battery.
2. Electric wires disconnect.
3. Display faulty.
4. Battery faulty.
1. Recharge the battery.
2. Verify the electrical wires routings.
3. Replace display.
4. Replace battery.
1. Verify the electrical wires routings.
2. Replace lever.
3. Replace lever.
4. Replace controller.
5. Replace motor wheel.
1. Replace rear brake.
2. Replace lever.
1. Replace display.
2. Replace controller.
1. Verify voltage value on charger.
2. Replace charger.
3. Replace battery.
1. Electric wires disconnect.
2. Accelerator lever faulty.
3. Brake lever faulty.
4. Controller faulty.
5. Motor faulty.
1. Rear brake faulty.
2. Brake lever faulty.
1. Display faulty.
2. Controller faulty.
1. Incorrect charger.
2. Charger faulty.
3. Battery faulty.
E-scooter doesn’t brake
correctly.
E-scooter wrong
indications on display.
E-scooter battery doesn’t
recharge.
E-scooter motor doesn’t
work correctly.
For correct your e-scooter operation and
use make sure the screws are tightened. If
necessary tighten the screws, shown in the
gure.
WARNING!