9
2.4 USING THE DISPLAY HANDSET.
IMPORTANT USER INFORMATION – READ THIS BEFORE ATTEMPTING TO OPERATE THE FIRE
NOTE: The handset is paired to the fire during manufacture. DO NOT ALTER THE PAIRING.
For safety reasons, the handset is designed so as to avoid accidental operation. If, during proper use, the
handset fails to communicate with the valve there is a possibility that the pairing has been inadvertently altered
– in this case the handset will need to be reset and re-paired with the valve.
For normal use:-
Prior to using the handset for the first time insert new, alkaline, AA batteries into the valve and handset. Ensure
they are mounted firmly and in the correct orientation, and that the battery covers are replaced fully. Ensure
the small isolation switch on the gas control is switched to the ON (I) position.
Hold the handset as shown, wrapping your hand around the handset to make good
contact with both sides. The green unlock light should illuminate, activating the buttons
(if the light is not illuminated, the buttons will not work).
Press and hold the power button, release as soon as PILOT appears on the display
(approx. 1-2 seconds). The fire will commence ignition sequence. If successful, the fire
will automatically go to maximum heat output.
NOTE: Releasing the power button too soon or depressing for too long after the PILOT appear, will cause the
fire not to light because system assumes press to be unintentional.
To adjust the flame, hold handset to activate buttons, and use + and – to increase or
decrease flame power accordingly. Tapping the button will increase or decrease flame
stepwise, holding the button will skip through steps. The fire basket display on the
handset will illustrate the level of flame being produced.
To STOP the fire, hold handset to activate buttons, then press the power button. The
fire should shut off immediately (n.b. residual heat will remain). If you wish to start the
fire again you must wait for OFF to be displayed on the handset before trying to re-start.
NOTE: THE HANDSET IS DESIGNED TO MAKE REMOTE OPERATION OF THE FIRE AS SAFE AS POSSIBLE. IT HAS BEEN SPECIFICALLY
DESIGNED TO MINIMIZE THE RISKS OF ACCIDENTAL OPERATION, WITH THE EXPRESS INTENTION THAT SUCCESSFUL OPERATION CAN
ONLY BE ACHIEVED BY A CONSCIOUS, DELIBERATE ACT. ERGO IT MAY TAKE SOME TIME TO BECOME FAMILIAR WITH THE INTRICACIES
OF HANDSET OPERATION.
To Next Page
Loading...