What to do if Thermador PRO HARMONY PRD364WDGU Ranges igniter clicks more than four times before lighting?
If you're experiencing more than four clicks of the igniter before lighting on your Thermador Ranges, ensure the burner cap is properly aligned on the burner base.
What to do if my Thermador Ranges won't turn on?
If your Thermador Range won't operate, and the lights, oven, and surface burners won't come on, first check for an open circuit breaker. Also, verify that the oven is not in Sabbath Mode.
Why is the igniter constantly sparking on my Thermador PRO HARMONY PRD364WDGU Ranges?
If the igniter on your Thermador Ranges is sparking constantly, it could be due to improper grounding or an incorrectly polarized electrical power supply. Refer to the Installation Manual and have a qualified electrician ground the range properly.
Why are foods not cooking properly in my Thermador PRO HARMONY PRD364WDGU Ranges oven?
If foods in your Thermador oven are not cooking sufficiently, check the rack position. Also ensure you are using proper cookware. Clean the oven door gasket and replace it if it is worn. Finally, refer to the Installation Manual for instructions on how to level the appliance.
What to do if the Thermador PRO HARMONY PRD364WDGU Ranges door will not open?
If the door of your Thermador Ranges will not open, it is possible that the oven is still in self-clean mode. If the oven is hot, the door latch will release when a safe temperature is reached.
Why are the igniters sparking but no flame on my Thermador Ranges?
If the igniters are sparking on your Thermador Ranges, but there is no flame ignition, make sure the gas supply valve is in the “ON” position to restore gas supply to the unit.
Why is hot air coming from my Thermador PRO HARMONY PRD364WDGU?
If you notice hot air coming from your Thermador Ranges, it is normal for the cooling process to push heated air out into the room when the oven is on. During different modes the fan speed will increase and decrease - this is also normal.
How to fix intermittent igniter sparking on Thermador Ranges?
If the igniter on your Thermador Ranges is sparking intermittently, it could be because the ceramic igniter is wet or dirty. Carefully dry or clean the igniter. Also, the burner ports might be clogged. Clean the ports on the burner cap with a wire, a needle, or a straightened paper clip.
To Next Page
General