What to do if "E" and a number appears in display of Thermador Pro Harmony PRG486WH?
If "E" and a number appear in the display of your Thermador Ranges, an electronics fault has occurred. Press TIMERS to stop the beeping. Reset the oven if necessary. Call an authorized service provider.
What to do if my Thermador Pro Harmony PRG486WH Ranges oven door is locked and will not open?
If your Thermador Ranges oven door is locked, even after cooling, the door lock might be engaged. Turn the oven off at the circuit breaker and wait five minutes, then turn the breaker back on.
How to fix Thermador Pro Harmony PRG486WH oven light that won't turn off?
If the oven light in your Thermador Ranges doesn't turn off, check the oven door for obstructions and ensure it closes properly. Also, check if the hinge is bent. You can also press the oven light button to turn the oven light off, if it's on.
What to do if my Thermador Ranges oven is not self-cleaning properly?
If your Thermador Ranges oven isn't self-cleaning properly, allow the oven to cool before running self-clean, especially if it's too hot to start. Always wipe out loose soils or heavy spillovers before running self-clean. If the oven is heavily soiled, set the maximum self-clean time.
Why is the burner flame not uniform on my Thermador Ranges?
If the burner flame on your Thermador Ranges is not uniform, the burner parts might not be positioned correctly; make sure to position them correctly. Also, the grooves on the burner might be dirty; clean the grooves.
How to fix Thermador Pro Harmony PRG486WH clock and timer that are not working?
If the clock and timer on your Thermador Ranges are not working, check the circuit breaker or fuse box to ensure there is a power supply to the appliance. Make sure there is proper electrical power to the oven. Also, clean the control panel and wipe it dry if it is wet or soiled. Ensure you press the center of the button using the flat part of your finger.
What to do if Thermador Ranges igniters are sparking but no flame?
If the igniters are sparking on your Thermador Ranges, but there is no flame ignition, make sure that the gas supply valve is in the 'ON' position to restore gas supply to the unit.
Why is hot air coming from my Thermador Ranges?
It is normal for the cooling process to push heated air out into the room when the oven is on. Also, during different modes, the fan speed will increase and decrease.
Why does the Thermador Pro Harmony PRG486WH Ranges igniter click more than four times before lighting?
If your Thermador Ranges igniter clicks more than four times before lighting, the burner cap might not be properly fitted onto the burner base. Make sure to align the burner cap correctly on the burner base.
How to fix intermittent igniter sparking on Thermador Ranges?
If you're experiencing intermittent igniter sparking with your Thermador Ranges, the ceramic igniter may be wet or dirty. Carefully dry or clean the igniter. Also, burner ports could be clogged. Clean the ports on the burner cap with a wire, a needle, or a straightened paper clip.
General| Brand | Thermador |
|---|---|
| Model | PRG486WH |
| Category | Ranges |
| Width | 48 inches |
| Number of Burners | 6 |
| Second Oven Capacity | 2.5 cu. ft. |
| Fuel Type | Gas |
| Color | White |
| Burner Power | up to 18, 000 BTU |
| Cooktop Material | Porcelain |
| Ignition Type | Electronic |
To Next Page