For Integral Blower Installations:
• Requires Integral Blower: Model # VTN600CVA
• Requires Round Duct Size (6" Diam.)
• Requires Dedicated Branch Circuit Power Supply • 120 Volt AC•
min. 15 Amps., 3 prong receptacle • 60 Hz.
• See Steps 3 and 5 for electrical receptacle and duct outlet location
For Remote Blower Installations:
• Requires Remote Blower: Model # VTR1000Q or VTR600R
• Requires Duct Transition: Model # CVT314 (for 3
-1
/4" x 14" duct) or
Model # CVT7 (for 7" Diam. Round)
• Requires 4 wires and 1 ground wire connecting blower and vent
• Requires Dedicated Branch Circuit Power Supply • 120 Volt • 15 Amps.,
3 prong receptacle • 60 Hz., AC.
For CVT314:
• Recommend 3
-1
/4" x 14" to 10" diam. transition for VTR1000Q Remote Blower
• Recommend 3
-1
/4" x 14" to 8" diam. transition for VTR600R Remote Blower
For CVT7:
• Recommend 7" diam. to 10" diam. transition for VTR1000Q Remote Blower
• Recommend 7" diam. to 8" diam. transition for VTR600R Remote Blower
• See Steps 3 and 5 for electrical receptacle and duct outlet location
UNIVERSAL COOK’N’VENT
®
INSTALLATION INSTRUCTIONS
MODELS: UCV30 • UCV36 • UCV45
Rating: 120 Volt, 60 Hz., 10.0 Amps.
INSTALLATION MUST COMPLY WITH ALL APPLICABLE CODES.
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.
IMPORTANT: Save these instructions for the local electrical inspector's use.
INSTALLER: Please leave these Installation Instructions with this unit for the owner.
OWNER: Please retain these instructions for future reference.
SAFETY WARNING: Disconnect power by removing plug from receptacle before installing
or servicing this unit.
To Next Page
Need help?
General
