To Next PageTo Next Page
Need help?Do you have a question about the Thermann 135THM4N and is the answer not in the manual?
General| Brand | Thermann |
|---|---|
| Model | 135THM4N |
| Category | Water Heater |
| Language | English |
The water heater must be installed outdoors, with minimum clearances as shown in the figure.
Must be installed by a licensed tradesperson according to AS/NZS3500.4, AS/NZS 5601.1, and local regulations.
Details the PTR valve, its rating (1400kPa), installation, and maintenance requirements.
Mandatory fitting of a temperature control device to reduce scald injury risk, requiring regular checks.
Step-by-step instructions for lighting the pilot and main burner, including safety precautions.
Includes Model Numbers, Capacity (L), Net Weight Empty (kg), Relief Valve Pressure (kPa), Gas Consumption.
The main burner pressure must be set at installation and checked using a water manometer or equivalent.
Discusses suitability for Australian metropolitan supplies and the effect of Total Dissolved Solids (TDS) on the heater.
Details the mandatory 5-year service by a licensed tradesperson, including valve and anode replacement.
Points to consider for insufficient hot water, including usage, burner status, and valve discharge.
Benefits provided by warranty and guarantee, in addition to ACL rights, and exclusions.
Details the 1-year full parts and labour warranty and the 7-year inner cylinder replacement guarantee.
