1717
Thermann Owner's Manual
Thermann X Split Heat Pump
1716
WARRANTY POLICY
All Thermann water heaters must be installed in accordance with manufacturer’s
installation instructions and in accordance with local regulations, building codes and AS/
NZS 3000, AS/NZS 3500.4 and AS/NZS 5601.
Where a component may have failed under warranty and is replaced, the component
replaced will only be covered by the warranty for the balance of the appliance warranty
period.
Water quality must be within limits specified in table below.
pH 6.5 to 8.0
Sodium Up to 150 mg/litre or ppm
TDS (Total Dissolved Solids) Up to 600 mg/litre or ppm
Chlorides Up to 300 mg/litre or ppm
Iron Up to 1 mg/litre or ppm
Magnesium Up to 10 mg/litre or ppm
Alkalinity (as CaCO3) Up to 200 mg/litre or ppm
Dissolved (free) CO2 Up to 25 mg/litre or ppm
Total Hardness CaCO3 Up to 200 mg/litre or ppm
WARRANTY TERMS
Thermann Split Heat Pump hot water systems are covered by Reece for any cost of labour
and parts in the event of a component failure due to any defects that may arise either from
workmanship and/or faulty material.
The warranty commences on the date of installation:
Domestic
Heat Pump Unit: 6 years
Tank: 10 years
Parts & Labour: 2 years
Commercial
All components: 1 year
Parts & labour: 1 year
NEED MORE INFO?
Visit www.thermann.com.au to get the latest product information and
explore rest of the Thermann Hot Water range.
To Next Page
Loading...
