30 | P a g e
Part Number - 00824 Revision K, DCO 2017-0074
© 2017 Thermedx
®
, LLC
Power down the unit using the power switch.
Allow the unit to cool if needed and reboot. If
the problem persists, call for support.
For Ureteroscopy, there is a persistent
message indicating pressure set-point is
elevated, normally above 75mm Hg. A
proper relief valve will be required in these
circumstances. See Help Menu for specific
instructions.
During some procedures, the pressure can
be increased to potentially unsafe levels.
Press the notification to confirm fluid
pressure set-point increase during specific
procedures.
High fluid deficit may affect patient safety.
Press the notification to confirm deficit set-
point increase during specific procedures.
To Next Page
