THERMEx Typhoon - Installation; Location of the Device

M 525211282207062021 THERMEX TYPHOON 73
ENGLISH
»
INSTALLATION
INSTALLATION
Assembly and installation should only be carried out by qualified personnel who have knowledge of the applicable building element.
Ensure the following before starting the installation:
• The surface / table top where the unit is to be mounted must be horizontal and have sucient space.
• The surface / table top is suciently resistant to heat.
• If the unit is mounted above an oven, the oven must have a built-in cooling fan or be insulated.
• The installation must comply with the applicable rules and standards for installation, as well as the space requirements around the unit.
• If in doubt about the applicable building element, it is recommended to consult the local authorities.
• Always use heat-resistant cleaners on and around the unit.
Location of the device:
The unit should ideally be positioned so that there are no kitchen cabinets or walls next to the unit. If this is not observed, the eciency decreases.
Check the minimum dimensions of the table in which the unit is to be mounted. The minimum height of the plinth must be 100mm if it is desired
to secure space for the piping under the cabinet.