Electric boilers MINI BTH Installation & Operating Manual (Revision: May 2015), 6
*In position #5: on boilers MINI BTH 3 to 6kW, the heating element located in the upper section of the boiler must be
relocated into the lower opening.
**In Position #6: the temperature setting of element #1 must be adjusted at a temperature slightly higher than the one
of element #2.
3.4 BOILER WATER CONNECTIONS
Make sure you connect the accessories and the piping to the proper connection fittings as indicated at
figure 2 above and according the selected mounting position.
Figure 3 below shows typical connections of a MINI BTH 2.0 boiler to a radiant floor heating system. The
location of the distribution system components may be different from what is represented.
Figure 3 : Typical installation on radiant heating floor
Figure 2 : Mounting positions
To Next Page
Loading...
