EasyManuals Logo

Thermo IEC Centra-GP8R User Manual

Default Icon
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Centra-GP8/GP8R Operation Manual
6
Power cord
The Centra-GP8R requires a grounded power supply (3-prong power
outlet). If your facility does not have properly grounded outlets, arrange
for proper grounding.
IEC provides two power cords with each Centra-GP8 and Centra-GP8R.
One is suitable for North America, Japan and Korea. The other has bare
wires at one end so other plug types can be attached.
Caution: Do not remove the grounding pin from the centrifuge
power cord. Do not use the bare wire power cord to attach a power
plug that does not have a grounding pin. Use only the appropriate
power cord supplied by IEC.
If the bare wire power cord is used, install the selected plug and attach
the cord to the receptacle on the lower left side of the centrifuge. Plug into
the power outlet.
Warning: The power cord(s) provided with the unit is correctly rated
for the highest current demand. This power cord should not be
interchanged with cords from equipment with lower current
demand. Exchange of power cords between equipment may create
a fire hazard.
2.4 Moving the Unit
If you relocate a GP8 series centrifuge to a different power source, please
refer to section 2.3 to check the power requirements and, if necessary,
reconfigure the power.
Benchtop First, remove the rotor and accessories. Next, release the seal
on the suction cups that adhere the Centra-GP8/R to the work surface.
Lift the edge of each suction cup to release the seal and insert an object
such as a tongue depressor underneath to prevent the cup from
resealing. Position the device in its new location and check the cups to
ensure they are gripping the benchtop properly.
Kneewell To move the kneewell centrifuge, remove the rotor and accessories.
Unlock the front casters and grasp the centrifuge by its side handles and
wheel into position. Maneuver it backward to expose the locking casters
again. Lock down the casters.
Warning: Lock the front wheels before starting a run to avoid
dangerous movement.
Floor Model To move the floor model centrifuge, remove the rotor and accessories.
Unlock the front casters and grasp the centrifuge by the corners of the
cabinet and wheel into position. Maneuver it backward to expose the
locking casters again. Lock down the casters.
Warning: Lock the front wheels before starting a run to avoid
dangerous movement.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Thermo IEC Centra-GP8R and is the answer not in the manual?

Thermo IEC Centra-GP8R Specifications

General IconGeneral
BrandThermo IEC
ModelCentra-GP8R
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals