Thermo King TriPac DPF - Cancelling a Regeneration

DPF Operation
26
Cancelling a Regeneration
To cancel the regeneration process:
• Press the bottom (OFF) of the Regeneration switch.
• The flashing amber DPF STATUS light will go out,
the regeneration process will stop and the HMI will
display [Eng] code.
• The regeneration process should be initiated again at
the drivers earliest convenience.
NOTE: The TriPac APU will be disabled when the DPF is in
the regeneration mode or if the DPF regeneration switch is in
the OFF position.
DPF Operation
26
Cancelling a Regeneration
To cancel the regeneration process:
• Press the bottom (OFF) of the Regeneration switch.
• The flashing amber DPF STATUS light will go out,
the regeneration process will stop and the HMI will
display [Eng] code.
• The regeneration process should be initiated again at
the drivers earliest convenience.
NOTE: The TriPac APU will be disabled when the DPF is in
the regeneration mode or if the DPF regeneration switch is in
the OFF position.