Thermo NESLAB RTE10 User Manual

Installation
Operation
Basic Maintenance
Thermo Manual P/N U00694
Rev. 05/20/04
NESLAB RTE Series
Refrigerated
Bath/Circulators
No part of this publication may be repro-
duced or reprinted except for personal use
without the prior permission of Thermo
Electron.

Thermo NESLAB RTE10 Specifications

General

Brand	Thermo
Model	NESLAB RTE10
Category	Chiller
Language	English

Summary

Section I Safety

General Safety Warnings

Important instructions and warnings to prevent damage, injury, or death.

Section III Installation and Operation

Electrical and Plumbing Connections

Instructions for connecting power and fluid lines, including requirements.

Fluid Selection and Handling

Controller Interface and Basic Operation

Explanation of the control panel buttons, indicators, and basic start-up/shutdown.

Temperature Setpoint and Alarm Configuration

Setup/Tuning Loop Configuration

Guide for configuring PID parameters, auto-restart, and operational modes.

Serial Communication Setup

Analog Port and High Temperature Cutouts

Section IV Basic Maintenance

Condenser Cleaning

Calibration Procedures

Internal and External Sensor Calibration

How to calibrate internal and external temperature sensors.

Analog Port Calibration

Section V Troubleshooting

Error Codes and Unit Indicators

Listing and explanation of error codes and status indicators.

Troubleshooting Common Issues

Checklist and guidance for resolving operational problems like poor cooling and communication.

Appendix A Fluids

Recommended Fluids Compatibility

Appendix B NC Serial Communications Protocol

Serial Communication Command Reference

Warranty Information