ThermoFlow DS 30 User Manual (English)

Questions and Answers:

B
bthomasAug 12, 2025
Why is the water at my ThermoFlow DS 30 Water Heater cold?
- A
  abigailbakerAug 12, 2025
  If the water at the appliance outlet is cold, first check if there's a mains power loss and restore the power supply if needed. Also, inspect the electrical socket for bad contact and replace it if necessary. If these steps don't resolve the issue, it may be due to a faulty temperature limiter or thermostat, an open circuit or damaged appliance, a tripped temperature limiter, a temperature limiter fault, a faulty thermostat, or damaged ON-OFF switch electrical wiring, in which case you should call service for the necessary repair. Finally, if the heating time was insufficient, wait for the water to heat up.
L
Lisa HendricksAug 19, 2025
What to do if there is no water at the hot water outlet of my ThermoFlow DS 30 Water Heater?
- V
  Valerie MartinAug 19, 2025
  If there's no water coming from the hot water outlet of your ThermoFlow Water Heater, it could be due to a few reasons. First, check if the water supply has been interrupted and wait until it is restored. Next, check for low water pressure and wait until the pressure has increased. Finally, ensure that the water inlet valve is open; if it's closed, open it.
R
rwilliamsonAug 26, 2025
Why is the water temperature too high in my ThermoFlow Water Heater?
- C
  Casey MillerAug 27, 2025
  If the water temperature from your ThermoFlow Water Heater is excessively high, it indicates a temperature control system fault, and you should call service for the necessary repair.
S
Shaun HardinSep 2, 2025
How to fix a water leak in my ThermoFlow Water Heater?
- S
  Stacy YoungSep 2, 2025
  If you notice a water leak in your ThermoFlow Water Heater, it could be due to a joint on one of the pipes not being watertight. In this case, you should seal the joints to resolve the leak.