19 Barnstead|Thermolyne • 800-553-0039
To adjust parameters while running a program, you must put control into "Hold." Push "PAR" until "prog"
is displayed. Push "UP" or "DOWN" buttons until Hold is displayed. When the dot underneath "R" on
controller flashes and "Hold" is indicated at the "prog" parameter, the controller is in Hold. Now you are
able to adjust all parameters. To restart the program, set "prog" to "run" again.
Program Idle
To stop program, push "PAR" button until "prog" is displayed. Push "UP" or "DOWN" buttons until "idle" is
displayed. This will terminate program.
To Next Page
Loading...