Teflon Cover
Clean the Teflon Cover frequently by wiping with a soft clean rag. A
non-flammable cleaner such as “Ez-Off,” (P/N DH-6873), may be used according
to the manufacturer’s instructions. NEVER USE A FLAMMABLE SOLVENT OR
ABRASIVE CLEANER. To ensure the best heat-sealing results, replace the Teflon
Cover whenever it becomes torn or too soiled to clean.
Procedure to Replace Teflon Cover
1. Turn the machine off, unplug it and allow it to cool down.
2. Turn the machine upside down.
3. Peel the old Teflon cover off of the surface of the heater.
4. Use a razor blade to scrape all of the old adhesive off of the heater. All old
adhesive must be removed.
Do not use any liquid cleaners on the heater.
5. Peel the yellow backing off of the Teflon to expose the adhesive. Discard the
yellow backing.
6. Stick the Teflon onto the heater and rub out any air bubbles.
7. If necessary, trim off any excess Teflon.
8. Turn the machine over, back to its proper position.
9. Plug in the machine and turn the power “ON.” Allow it to warm up.
The machine is now ready to use.
Lower Press Platen
Clean frequently by wiping with a soft, clean rag. Replace the pad whenever it
becomes deteriorated. To replace the Lower Press Platen:
1. Switch the Heat Sealing machine to the “Off” position and allow the Heater
Element to cool down to room temperature.
2. From the side, gently wedge a screwdriver between the aluminum base and
aluminum backing plate of the platen assembly. The Lower Press Platen can now
be removed from the base.
Lubrication
The HS3E and HS4E machines do not require lubrication.
5. Maintenance
To Next Page
Loading...
