Thermoplan Black&White 3 CTS - Error Codes and Sensor Issues

25
© 2009 by Thermoplan AG , Subject to change
User Manual CT / CTS / CTMcool
805.012_REV-1_EN
Display messages What?
Piston error
1. Reselect any beverage
2. If not OK => contact service
Overtime error
Coffee extraction time IS too slow, (grind adjustment may be too fine)•
1. Press Cleaning key
2. Repeat process
Water flow blocked•
1. Check
2. => contact service
NTC coffee
CPU does not receive signal from NTC sensor on coffee boiler•
1. => contact service
NTC Foamer
CPU does not receive signal from NTC sensor on Foamer heating•
1. => contact service
If for any reason the machine had to be turned off,
wait at least for 10 sec. before turning on again!
User display messages