3-6 E1922 Wide Flat Panel Monitor User’s Guide
Installing the monitor driver in Windows 7
To use the Plug and Play feature in Microsoft Windows 7, do the following:
Note: You must download file from the Reference and Driver CD to use the Plug and
Play feature in Windows 7.
1. Turn off the computer and all attached devices.
2. Ensure that the monitor is connected correctly.
3. Turn on the monitor and then turn on the computer. Allow your computer to boot
into Windows 7 operating system.
4. Open the Display Properties window by clicking Start, Control Panel and then
click the Hardware and Sound icon.
5. Click the Display icon.
6. Click the Adjust Resolution button.
7. Click the Advanced Settings button.
8. Click the Monitor tab.
9. Click the Properties button.
10.Click the Driver tab.
11. Open the "Update Driver Software-Generic PnP Monitor" window by clicking on
Update Driver and then click the "Browse my computer for driver software" button.
12. Select “Let me pick from a list of device drivers on my computer”.
13. Insert the Lenovo Monitor CD into the CD drive and click the Have Disk button.
14. Click on the Browse button and navigate to the following directory:
X:\Monitor Drivers\ (where X is the drive letter designator for the CD-ROM drive).
Select the “E1922 wD.inf”file and click the Open button. Click the OK button.
15. Select E1922 wD and click Next. The files will be copied from the CD to your
hard disk drive.
16. Close all open windows and remove the CD.
17. Restart the computer.
The system will automatically select the maximum refresh rate and corresponding
color matching profiles.
Note: On LCD monitors, unlike CRTs, a faster refresh rate does not improve display
quality. Lenovo recommends using either 1366 x 768 at a refresh rate of 60 Hz, or 640 x 480
at a refresh rate of 60 Hz.
To Next Page
Loading...
Need help?
General