THINKWORK P550 - Page 5

04
5.Polish the project to be sprayed to increase the smoothness of the object and the adhesion of the paint. For
example: wood, wall, metal rust, car surface, floor, etc.
6. Filter the paint to prevent impurities in the paint (usually use a 150~190 micron filter).
7. Use masking glue or plastic film to cover the areas that do not need to be sprayed to avoid paint contami-
nation. For example: floors, light switches, door handles, etc.
Use the Sprayer
Step 1:Wear necessary protective equipment:goggles, gloves, masks.
Step 2:Choose a suitable nozzle according to your project (refer to Fig 3), and install the paint sprayer (Fig 4).
Step 3: Test the viscosity of the paint(Fig 5), and add 5% or 10% water(thinner) each time to dilute the paint to
a certain viscosity(Fig 3).
Nozzles
Recommended
Materials
Recommended
Viscosity
Project
1.0 mm
sealers,stains,enamel
,varnish
25
table,chair,doors,bicycle,car,shutter,cabininets,w oo
den toys,model
1.5 mm
polyurethane,chalk
and milk type paint
30
railings,multi-frame w indow frames,heating
pipes,boats,yard furniture,garage doors,metal
garden fences
1.8 mm
low viscosity w all
paint
40 internal w alls,corridor
2.0 mm
low viscosity primer
paint
45 w ooden garden fence,w ooden pile
2.5 mm
low viscosity latex
50
external w alls,outdoor floors
(Fig 3)
(Fig 4)
(Fig 5)