03
(Fig 2)
Applicable Accessories
In spraying projiect, these accessories are necessary, and you don’t need to buy them separately:(Fig 2)
●
A:Masking Paper: Before starting your project, please use it to cover the areas that do not need to be
sprayed. Size: 12”*66'(30cm*20m)*1; 22”*66'(55cm*20m)*1.
●
B:A pair of gloves:wear gloves before starting work.
●
C:Paint brush: there are some narrow corners that cannot be entered by the paint sprayer. however, the
brush is used anywhere.
●
D:Glasses:it can prevent dust and paint from getting into your eyes.
●
E:Filter funnel: it is used to filter impurities in paint. Specifications: 100 mesh, 170 microns.
●
F: Storage bag:it is used as a storage bag for sprayers and accessories.
Before Use the Paint Sprayer
1.Wear necessary protective equipment: goggles, gloves, masks, etc. They can protect you from dust, noise,
and paint.
2.Install the sprayer and put in water to test to see if the machine is normal. Does the motor rotate? Are the
airflow and paint channels blocked? Is the spiral pattern of the jar leaking? Are the flow trigger and direction
adjustment knob working properly?
3.Generally, paint needs to be diluted to a suitable viscosity before it can be loaded into the sprayer. The
product is equipped with a funnel specially used to test the viscosity of the paint. How to use the funnel:
temporarily block the bottom of the funnel and fill it with paint so that the lowest level of the paint is level with
the highest part of the test cup, loosen the funnel and start timing, let the paint flow out of the funnel naturally,
until the paint produces discontinuous drops Instead of a continuous "line", stop timing. The seconds of the
timer at this time are the viscosity of the paint, which we call: DIN-s. For example, if we fill the viscosity test
funnel with varnish, and the varnish runs out in 80 seconds, we call the viscosity of the varnish at this time is
80 DIN-s. The maximum viscosity of the paint that this paint sprayer can spray is 100 DIN-s, however,we
generally dilute the paint to 30-45 DIN-s to get a smoother finish. Please add 5% or 10% water or thinner
each time to dilute the paint.Generally, the proportion of thinner cannot exceed 30% of the paint.
4.Find and install the right size nozzle.The larger the diameter of the nozzle means the faster the sprayer
spray, the larger viscosity of paint it can spray, and the worse finish the project will be. please refer to the
sheet:Fig 3.
C
E F
D
A
B
To Next Page
Loading...