Third Reality RealitySwitch Plus - Page 7

Please remove the protection films on the
surface of the switch body.
3) Place the switch body onto your backplane,
making sure to match the “up” direction (you
can remove it first from the down direction).
4) In some special cases, it is necessary to insert
spacers and/or gaskets in the backplane. You
may adjust the screws in the backplane to
ensure proper contact.
Note: The spacers are only used by the Roc
ker Backplane.
Install
Take off
Install
Take off
Rocker
Toggle
Rocker
Backplane
Spacers and/or
gaskets inserted