Thitronik WiPro - Page 127

1. Handling the system
Please read the following instructions carefully
to avoid faulty operation.
1.1 Controlling the system with the remote key fob
The “lock” button arms the system.
Only possible with the vehicle doors closed
 ToarmthesystemonFordTransits,brieypress
the button twice in succession.
 Thevehicleindicatorsashtwice(dependingonthevehicletype),
theinteriorbeepersoundsonceandthestatusLEDstartstoash.
If the interior beeper makes a series of beeps
when locking the vehicle, one or more wireless contacts
are open but the system still arms itself
(see 1.4 ventilation function).
The “unlock” button disarms the system.
 Thevehicleindicatorsashtwice(dependingonthevehicletype),
theinteriorbeepersoundsonceandthestatusLEDstopsashing.
1.2 Controlling the system with the handheld transmitter
Any button arms the system.
Thevehicleindicatorsashonce,theinteriorbeepersoundsonceandthe
statusLEDstartstoash.
Feedback via vehicle indicators on vehicles without CAN bus only.
Any button disarms the system.
 Thevehicleindicatorsashtwice,theinteriorbeepersoundstwiceandthe
statusLEDstopsashing.
1.3 Activating the panic alarm
If you feel threatened while you are in the vehicle, use the panic alarm function
to draw attention. With a panic alarm, the siren, indicators and horn are activated
depending on the type of vehicle.
 IfaGSMmoduleistted,anemergencySMSissenttoallcallnumbers.
 IfaGPSreceiveristted,yourpositionisalsotransmitted.
A panic alarm can be activated with the system armed or disarmed.
The panic alarm is activated by pressing both buttons on the handheld
transmitter simultaneously.
The panic alarm is deactivated by pressing any button on the handheld transmitter.
WiPro „all in one“ Operating Instructions Page 1
!
!







GB