7 Pad volume
Use the faders in the [VOLUME MIXER] zone to adjust the volume of each indi‐
vidual pad.
The volume set with the faders is not saved for the respective drum kit.
1. Press [TEMPO].
ð
The tempo value in the lower right corner of the display appears in red.
2. Change the tempo with the rotary control or with [–] | [+] or press [TEMPO]
repeatedly until the desired tempo is reached.
3. Wait a few seconds without making any further changes or press [EXIT] to exit
the menu.
1.
Press to turn the Metronome on.
ð
The metronome clicks at the set tempo. Tempo and time signature are
shown in the lower right corner of the display.
When a song is playing or paused, the display shows the tempo and time
signature of the current song.
2. Wait a few seconds or press [EXIT] to exit the menu.
ð
The display now shows the standard values for tempo and time signature
again, which you can set in the ‘SETUP’ menu.
3.
Press to turn the Metronome o.
The drum module oers the possibility of recording up to 15 of your own songs.
1.
Press to activate the recording mode.
ð
The display shows ‘STANDBY’ at the bottom left.
2.
Set the tempo and press to start recording
or press / to record the current song. The set tempo is applied
or hit any pad to start recording straight away.
ð
If you do not start recording by hitting a pad, countdown beats will sound.
Changing pad volume
Changing the tempo
Turning the metronome on and o
Recording function
Operating
MPS-1000
15
To Next Page
Loading...
Need help?
General
