thomann Millenium MPS-1000 User Manual

6 Operating
The labelling of the display is described in English in these instructions. To
change the language, proceed as described under Ä Chapter 6.3 ‘ ‘SETUP’
menu’ on page 19.
Check all cable connections for correct t before turning on
Before switching on, turn both volume controls of the drum module down
to minimum.
Use the main switch [POWER] on the rear panel to switch the drum module on.
The device automatically switches to standby mode if you do not press any of the
buttons or hit any of the connected pads during the set interval (see
Ä Chapter 6.3
‘ ‘SETUP’ menu’ on page 19). Then press the main switch [POWER] to turn the device
back on again.
6.1 ‘KIT’ menu
After powering on the drum module, the display shows the following:
1 Main menu
2 Kit number
3 Kit name
4 Tempo
5 Time signature
6 Song status
A drum kit is a compilation in which a certain sound and several sound parameters
are assigned to each trigger. Selecting dierent drum kits lets you customise the
sound of your e-drum sets in seconds to the desired music genre.
Use the rotary control or [–] | [+] to select the desired drum kit ( ‘01’ … ‘80’ ).
As standard, the user kits ( ‘41’ … ‘80’ ) are copies of the preset kits ( ‘01’ … ‘40’ ).
Powering on
Standby function
%&
ö
# $
'
Selecting a drum kit
Operating
e-drum module
14

thomann Millenium MPS-1000 Specifications

General

Brand	thomann
Model	Millenium MPS-1000
Category	Music Equipment
Language	English