6. Press [–] | [+] simultaneously to restore the value set before the change.
7.
Some parameters have submenus. In this case, is displayed to the right of
the value. Press [ENTER] to switch to the submenu.
ð
Details on the respective parameter are displayed.
8. Press [EXIT] to exit the menu.
ð
A dialogue appears on the display.
9. Use the rotary control or [–] | [+] to select the target kit and conrm with
[ENTER] to save the changes. Or press [EXIT] to exit the menu without changes.
The following parameters can be changed with the rotary control or with [–] | [+]:
Parameter Values included values
Parameters for the individual triggers
‘GROUP’ ‘Kick’ Bassdrum
‘Snare’ Snare head, Snare rim, Cross stick
‘Tom’ Tom head, Tom rim
‘Ride’ Ride bow, Ride bell, Ride edge
‘Crash’ Crash bow, Crash edge
‘Hi-hat’ Hi-hat open, closed, half-open, pedal chick, pedal splash
‘Perc’ More percussions and FX sound
‘Loop’ Melody section (if a loop is assigned to a trigger, 4 bars of the melody are played
automatically when a trigger is struck, all loops are synchronized)
‘O’ No sound
‘User Sample’ Loaded samples
‘VOICE’
Voice selection, see
Ä
Chapter 11.3 ‘Voice list’ on page 36
‘VOLUME’ Volume setting
‘PITCH’ Adjusting pitch in semitones
Parameters for the individual drum pads
‘PAN’ Position within the stereo signal (panorama right / left)
‘PAD FX SEND’ Adjusting the eect strength of the pad
Parameters for the entire kit that cannot be set for each individual trigger and pad
‘KIT FX PRESET’ Selecting eect preset Some names are abbreviated. Press [ENTER] to view details.
‘KIT FX LEVEL’ Setting eect strength
‘KIT FX TIME’ Setting eect duration
The following table shows ‘FX LEVEL’ and ‘FX TIME’ for each ‘FX PRESET’ :
Operating
MPS-1000
17
To Next Page
Loading...
Need help?
General
