WARNING!
Danger of burns on the device surface!
The surface of the device becomes very hot during operation. Skin contact can result in burns. Never touch the device with your bare
hands during operation. After switching o the device, wait for at least 15 minutes before touching it.
CAUTION!
Risk of injury due to unexpected movements of the device!
The device head may perform fast movements and generate very bright light. This is the case immediately after the device is
switched on, in automatic or remote operation, and when a connected DMX controller is switched o. Persons who are in the imme‐
diate vicinity of the device may be injured or frightened by this. Make sure that there are no obstacles within the movement range of
the mirror, and that no persons are in the immediate vicinity of the head before switching it on and during its operation. Switch o
the device before any work is performed in the movement range or immediate vicinity of the device, or if unauthorised persons are
in that area.
NOTICE!
Risk of re due to covered vents and neighbouring heat sources!
If the vents of the device are covered or the device is operated in the immediate vicinity of other heat sources, the device can over‐
heat and burst into ames. Never cover the device or the vents. Do not install the device in the immediate vicinity of other heat
sources. Never operate the device in the immediate vicinity of naked ames.
NOTICE!
Risk of overheating and re due to inadequate distance and bad ventilation!
If the distance between the light source and the illuminated surface is too short or the device is badly ventilated, the device can
overheat and cause res. Make sure that illuminated surfaces are more than 2 m away. Do not operate the device in ambient temper‐
atures above 40 °C. Always ensure sucient ventilation at the operating location.
Safety instructions
10
Hero Barrel Scan 150
LED Scanner
To Next Page
Loading...
Need help?
General
