Thomas 315 SUPER CUT - Three-Phase Circuit Diagram

24 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

18

SUPER CUTSUPER CUT

SUPER CUTSUPER CUT

SUPER CUT

V 400 / 50 Hz

CIRCUIT DIAGRAM

THREE-PHASES

Table of Contents

Contents3
Ordering Spare Parts3
- Table of Contents3
Guarantee3
Machine Certification and Identification Marking4
CHAPTER 1 Reference to Accident-Prevention Regulations5
- Advice for the Operator5
- Location of Shields against Accidental Contact with the Tool5
- Electrical Equipment According to European5
- Standard "CENELEC en 60 204-15
- Emergencies According to European Standard "CENELEC en 60 204-1" (1992)5
CHAPTER 2 Recommendations and Advice for Use5
- Recommendations and Advice for Using the Machine5
CHAPTER 3 Technical Characteristics6
- Table of Cutting Capacity and Technical Details6
Chapter 4 Machine Dimensions Transport Installation Dismantling7
- Machine Dimensions7
- Transport and Handling of the Machine7
- Minimum Requirements for the Premises Housing the Machine7
- Anchoring the Machine7
- Instructions for Electrical Connection8
- Instructions for Assembly of the Loose Parts and Accessories8
- Disactivating the Machine8
- Dismantling8
CHAPTER 5 Machine Functional Parts8
- Operating Head8
- Vice8
- Bed9
CHAPTER 6 Description of the Operating Cycle9
- Starting up and Cutting Cycle9
Chapter 79
Regulating the Machine9
- Disk Head9
- Vice9
- Cutting Angle Adjustment10
- Changing the Disk10
- Changing the Lubricating Coolant Pump10
CHAPTER 8 Routine and Special Maintenance10
- Daily Maintenance10
- Weekly Maintenance10
- Monthly Maintenance10
- Six-Monthly Maintenance10
- Oils for Lubricating Coolant10
- Oil Disposal11
- Special Maintenance11
CHAPTER 9 Material Classification and Choice of Tool11
- Definition of Materials11
- Choosing the Disk11
- Teeth Pitch12
- Cutting and Advance Speed12
- Running in the Disk12
- Disk Structure12
- Type of Disks12
CHAPTER 10 Machine Components14
- List of Spare Parts14
Chapter 1118
Wiring Diagrams18
CHAPTER 12 Troubleshooting20
- Blade and Cutting Diagnosis20
- Electrical Components Diagnosis22
Chapter 1322
Noise Tests22
CHAPTER 14 Optional23
- Pneumatic Vice23
- Connection to the Pneumatic System23
Plates and Labels23
Notes24

Related product manuals

Thomas 300 SUPER CUT

Thomas 275 SUPER CUT