Need help?Do you have a question about the Thommen HM28 and is the answer not in the manual?
Overview of selectable settings like cut-out, resolution, units, transfer rate, and logging.
Critical warnings regarding maximum pressure, explosive environments, and eye protection.
Detailed steps for switching the gauge on and off, including warm-up procedures.
Instructions for correctly connecting pneumatic hoses to the pressure ports.
Explanation of various operating modes and their display examples and notes.
How to set measurement units, resolution, and damping parameters.
Setting the baud rate for RS232 and configuring the automatic shut-off timer.
Configuring time units for readings and setting measurement recording intervals.
Adjusting the display rate and performing general resets to default settings.
Details on remote operation via a PC using an RS232 interface.
Diagram and list of pin assignments for the RS232 DB9 female connector.
Information on ASCII commands, control command decoding, and reply formats.
Instructions for replacing the 9V battery or accumulator and proper disposal.
Guidance on recalibration, noting it should be done by specialist staff.
Specifies compatible media for measurement and material compatibility.
Details on measuring ranges, maximum loading capability, and resolution options.
Information on operating/storage temperature, humidity, IP rating, and power supply.
Lists conversion factors for different units like kPa, bar, mmHg, and psi.
List of optional accessories such as batteries, cases, pumps, and software.
Identifies common fault indications, their causes, and recommended remedies.
General| Brand | Thommen |
|---|---|
| Model | HM28 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
