Thommen HM28 - Page 19

19
e
setunit_mmh2o * 57
setunit_mmhg * 255
setunit_psi * 162
setunit_inh2o * 54
setunit_inhg * 252
setunit_hpa * 143
setunit_pa * 39
setunit_mpa * 148
setbaud_9600 * 1 CR (tab)[ok] * 13 CR Select baud rate (answer with
setbaud_4800 * 254 new baud rate, wait >0,1s
setbaud_2400 * 248 before "XON")
setbaud_1200 * 245
resolution_high * 62 CR (tab)[ok] * 13 CR Select measured value resolution
resolution_low * 240 and indication, high:10 M/s,
low: 20 M/s
settempmode_0 * 33 CR (tab)[ok] * 13 CR Temp. measuring will be switched
off at RS232 mode
settempmode_1 * 34 Temp. measuring will be done
periodical (standard value)
setrecint_off * 86 CR (tab)ok * 13 CR Select storage interval (secondes)
setrecint_man * 87 (tab)ok
setrecint_1 * 76 (tab)ok
setrecint_5 * 80 (tab)ok
setrecint_10 * 124 (tab)ok
setrecint_20 * 125 (tab)ok
setrecint_30 * 126 (tab)ok
setrecint_60 * 129 (tab)ok
setrecint_2m * 186 (tab)ok Select storage interval (minutes)
setrecint_3m * 187 (tab)ok
setrecint_5m * 189 (tab)ok
setrecint_10m * 233 (tab)ok
Control commands/syntax Answer from HM28/syntax Description