21
Note: If you don’t want to perform a tuner scan, select one of the available options anyway. You can skip the scan
at some later stage of the installation wizard. If you skip this step you can perform a channel search later using
the related Channels menu options.
The next step is the selection of the tuner mode. Select your tuner preference to install channels for Live TV
function. Antenna, Cable and Satellite options are available. Highlight the option that corresponds to your
environment and press OK or Right directional button to proceed.
Antenna
If Antenna option is selected, the TV will search for digital terrestrial and analogue broadcasts. On the next screen
highlight Scan option and press OK to start the search or select Skip Scan to continue without performing a
search.
Cable
If Cable option is selected, the TV will search for digital cable and analogue broadcasts. If any, available operator
options will be listed on the Select Operator screen. Otherwise, this step will be skipped. You can select only one
operator from the list. Highlight the desired operator and press OK or the Right directional button to proceed.
On the next screen select Scan option to start a search or select Skip Scan to continue without performing
a search. If Scan is selected a conguration screen will be displayed next. Scan Mode, Frequency (kHz),
Modulation, Symbol Rate (kSym/s), Network ID options may need to be set. To perform a full scan set the
Scan Mode as Full/Advance if available. Depending on the selected operator and/or Scan Mode some options
may not be available to be set. Once you are done with setting available options, press the Right directional
button to proceed. The TV will start to search available broadcasts.
Satellite
If Satellite option is selected, Satellite Type screen will be displayed next. Preferred Satellite and General
Satellite options will be available. Select one and press OK to proceed.
Note: Preferred Satellite and General Satellite options may not be available depending on the selected country.
In this case the DVBS Conguration Setting screen will be displayed after selecting the tuner mode as Satellite. If
Preferred Satellite option is selected, next screen will be Select Operator screen. You can select only one operator
from the list. Highlight the desired operator and press OK or the Right directional button to proceed. Some of
the following options may be preset depending on the selected operator in this step. Check the parameters
before proceeding and adjust if necessary.
For Austria and Germany Load channel list function, under search option General Satellite, is available.
To Next Page
Loading...