THOMSON CR80 - Clock and Alarm Configuration; Setting Clock and Alarms (FM;DAB)

- EN 6 -
Battery power:
Be sure that the batteries are inserted correctly to avoid damage to the appliance. Always remove the
batteries when appliance will not be used for a long period of time, as this will cause leakage to the
batteries and subsequently damage to your set.
Use batteries of the same type. Never use different types of batteries together.
Do not throw the battery into the re, or exposed to sunshine or the like.
If the liquid contained in the batteries comes in contact with eyes or skin, wash the area immediately
and carefully with clear water and consult a doctor.
Note the following information: Only use the power supplies listed below.
Start-up of the device/ introduction (FM version)
• Remove the protective lm from the display if it is still present.
• Press the “STANDBY/ MODE” button to turn on the device.
• Press the “STANDBY/ MODE” button again to switch into the standby mode.
Start-up of the device/ introduction (DAB version)
• Remove the protective lm from the display if it is still present.
• Press the “STANDBY/ FUNCTION” button to turn on the device.
• Press the “STANDBY/ FUNCTION” button for approx. 3 seconds to switch into the standby mode.
Power supply
Insert the DC jack to the back case of your clock radio. Then insert the AC/DC power adapter into a
standard AC wall outlet.
Back-up Battery (not supplied)
1) Open the battery compartment on the bottom. Turn the battery compartment lid in the direction
“OPEN”.
2) Insert a button cell battery of the type CR 2025. Ensure the correct polarity (see battery
compartment lid).
3) Close the battery compartment again.
Note: The back-up battery preserves the clock time in case of a temporary power blackout.
Setting the clock (FM version)
The system must be in standby mode in order to set the clock.
1) Press and hold the “TIME SET / SCAN” button for approx.2 seconds.
2) The hour digits start ashing. Use the “SCAN +” & “SCAN -” buttons to set the hours accordingly.
3) Press the “TIME SET / SCAN” button to conrm the hour.
4) Repeat step 2 and 3 to set the minute.
Setting the clock (DAB version)
The system must be in standby mode in order to set the clock.
1) Press and hold the “ENTER / CLOCK / PRESET” button for approx.2 seconds.
2) Use the “SCAN+” & “SCAN-” buttons to set the time format “12 / 24hr”.
3) Press the “ENTER / CLOCK / PRESET” button to conrm time format.
4) The hour digits start ashing. Use the “SCAN+” & “SCAN-” buttons to set the hours accordingly.
5) Press the “ENTER / CLOCK / PRESET” button to conrm the hour.
6) Repeat step 4 and 5 to set the minute / date.