THOMSON DS500 - Power and Clock Settings; Setting the Clock; Setting the Alarm

- EN 6 -
Power
CAUTION
• Risk of product damager! Make sure that the power
voltage corresponds to the voltage printed
on the back label.
•
Risk of electric shock! When you unplug the AC power cord always pull the plug from the socket.
Never pull the cord.
• Before connecting the AC power cord, ensure you have completed all other connections.
Place the unit in the desired position
and unravel the mains cable. Insert
the cable
into the supply socket and switch on if applicable.
Auto standby
When playing media from a connected device, the T
ower automatically switches to
standby if:
• No button is pressed for 10 minutes,
• No audio from a connected device for 10 minutes.
Setting Clock
After the unit is plugged into a mains supply or mains power failure, the display will show the “0:00” on
the LCD display
. The unit should be in standby mode to set the current clock.
1. Press MEM/TIME button, the digits for the display will blink.
2. Long press the
/ button repeate
dly until
correct hour is set. Press the MEM/TIME to conrm
the hour setting.
3. The minute digits on the display will blink.
4. Press the
/ button repeatedly until correct minute is set. Press the
MEM/TIME to conrm the
minute setting.
Setting Alarm
This unit can be used as an alarm clock, The Bluetooth device, USB, FM is activated to play at a preset time.
1. Press
to switch the unit to standby mode.
2. Make sure that you have set the clock correctly.
3. Press MEM/TIME button
in shutdown state, the display will ash ON to select setting alarm, and
will display the last alarm record.
4. Press the MEM/TIME conrm, the time display will blink.
5. Press
/ button repeatedly to set hour. Press
MEM/TIME to conrm.
6. Press
/ to set minute.
7. Press MEM/TIME to
conrm, and then press
/ to select CD/FM status. Press MEM
/TIME to
conrm.
8. The volume would turn up from 0 to 25 gradually.
9. Press MEM/TIME button
in shutdown state, the display will ash ON to select setting alarm, and
the display will blink.
10. Press the
/ to select OFF to cancel alarm.