9
If "PROGRAMMING COMPLETE" appears on the display of your PC / laptop / smartphone / tablet
and you see the red tick, programming is complete
The LED on the remote control goes out
Test the remote control If it is not working correctly, follow the steps below:
1
Increase / reduce the volume on your PC / laptop / smartphone / tablet This should be between
70 and 100%
2 Check that the connection cable was inserted correctly
3 Check the status of the batteries and replace them with new ones if necessary
4 Press the right and left arrow buttons on the remote control simultaneously until the LED lights
up constantly
5 Press "PROGRAM" to transfer the selected setting to the remote control
9
10
To Next Page
Loading...
