PPP Commands
E-DOC-CTC-20050531-0058 v1.0
491
PPP Commands
Introduction
This chapter describes the commands of the ppp command group.
Contents
This chapter covers the following commands:
ppp flush Flush all PPP interfaces. 492
ppp ifadd Create a new PPP interface. 493
ppp ifattach Attach a PPP interface. 494
ppp ifconfig Configure a PPP interface. 495
ppp ifdelete Delete a PPP interface. 499
ppp ifdetach Detach a PPP interface. 500
ppp iflist Display the PPP interfaces. 501
ppp ifscan Scan a PPPoE interface for available Access Concentrator and Service names. 502
ppp rtadd Add a route to the routing table when the PPP link comes up. 503
ppp rtdelete Delete the route for a PPP link. 505
ppp relay flush Remove all Ethernet interfaces from the PPP relay agent list and terminate all
sessions.
506
ppp relay ifadd Add an Ethernet interface to the PPP relay list. 507
ppp relay ifdelete Delete an Ethernet interface from the PPP relay agent list. 508
ppp relay iflist Display all Ethernet interfaces added to the PPP relay agent list. 509
ppp relay sesslist Add an Ethernet interface to the PPP relay list. 510
To Next Page
