Need help?Do you have a question about the THOMSON TG784-SIP and is the answer not in the manual?
General| Device Type | Wireless router |
|---|---|
| Wireless Standard | 802.11b/g |
| Ethernet Ports | 4 |
| USB Ports | 1 |
| WAN Ports | 1 |
| Maximum Wireless Speed | 54 Mbps |
| Security Protocols | WEP, WPA, WPA2 |
| Interfaces | Ethernet, USB |
| VoIP | Yes |
| Protocols | SIP |
| Ports | 4 x Ethernet, 1 x USB |
Provides reference for the Command Line Interface (CLI) for the Thomson TG784.
Configures the CWMP daemon's parameters as seen from the ACS.
Configures the CWMP daemon towards the ACS server.
Configures a DHCP server pool with IP address range and gateway.
Configures URL filtering settings, including blocking and default actions.
Configures the web filter settings like state and server reachability.
Modifies or displays bridge configuration settings.
Modifies an Ethernet interface configuration.
Configures common Quality of Service (QoS) parameters.
Displays or modifies the global firewall configuration.
Adds a new rule to a firewall chain.
Configures the Device Discovery daemon parameters.
Displays or modifies IDS configuration settings.
Configures the IGMP proxy settings and behavior.
Configures an autoIP interface with address and pool settings.
Displays or modifies global IP stack configuration parameters.
Adds a route to the routing table.
Modifies IP QoS configuration for a specific interface destination.
Modifies IP QoS EF timer configuration for an interface.
Modifies the IP QoS subqueue configuration.
Adds a rule to a label chain.
Executes an mbus command with specified parameters.
Modifies the global NAT configuration.
Modifies address translation on an IP interface.
Adds an address mapping to a NAT-enabled interface.
Modifies the configuration of a PPP interface.
Adds a route to the routing table when a PPP link comes up.
Assigns a service to a specific host.
Modifies the configuration of an existing service.
Downloads firmware or configuration files to the modem.
Reboots the modem to initiate a software upgrade.
Sets or changes system configuration parameters.
Reboots the modem to restart its operations.
Adds a new certificate for the ACS client.
Adds a new certificate for the HTTPS server.
Displays or modifies TLS settings for the HTTPS server.
Adds a schedule object to define time-based actions.
Adds a new user account with specified properties.
Modifies the configuration of an existing user account.
Configures Call Admission Control (CAC) parameters.
Adds an entry to the voice dialplan for call routing.
Adds a new SIP profile for voice port configuration.
Configures the general SIP parameters.
Configures wireless interface settings.
Configures Quality of Service (QoS) settings.
Resets wireless interface settings to default values.
Modifies or displays DSL configuration parameters.
To Next Page
