THOMSON TG784-SIP - Atm Oam CC Modify

atm Commands
52
E-DOC-CTC-20080619-0007 v1.0
atm oam cc modify
Modify CC on the connection.
SYNTAX:
atm oam cc modify port = <{dsl0|dsl1|atm2|atm3|aal5|atm5} or
number>
vpi = <number{0-31}>
[vci = <number{0-511}>]
[transmit = <{disabled|enabled}>]
[receive = <{disabled|enabled}>]
[auto = <{disabled|enabled}>]
[span = <{segment|end2end}>]
where:
port The ATM port number. REQUIRED
vpi The Virtual Path Identifier. REQUIRED
vci The Virtual Channel Identifier. OPTIONAL
transmit Enable/disable transmission of CC cells. OPTIONAL
receive Enable/disable loss of continuity. OPTIONAL
auto Enable/disable remote CC activation/
deactivation.
OPTIONAL
span End2end or segment continuity check. OPTIONAL